South Wales French Car Owners club
Please log in to read the Forum

Boot pop SWFCOLogo

Join the forum, it's quick and easy

South Wales French Car Owners club
Please log in to read the Forum

Boot pop SWFCOLogo
South Wales French Car Owners club
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Boot pop

Go down

Boot pop Empty Boot pop

Post by Simon Sun 18 Apr 2010, 08:18

for this method you need

a length of single core cable (2-3m long)
2 bullet/spade connectors (1 male-1 female)
1 push switch
1 ring connector

and a short bit of wire

first off i was doing this on a 306 which has had the wiper removed, so i just used the red plug straight to the central locking motor

Boot pop Fd62f10d

if you want to fit this to a car with the wiper motor still fitted you'll need to bridge off the live (brown wire on the red plug)

I then used the grey wire on the plug located on the top of the drivers side wheel arch

Boot pop 004fd533

Boot pop A0d8d944

Cut the grey wire (an earth) then run it to the switch and from the switch to earth

This method will only work with the ignition turned on

Also if you are using a wiper motor use a different wire as an earth Smile

this gets your motor working then i attach wire around the hole in the motor to the hole for the boot latch
Simon
Simon
ADMINISTRATOR

Town/County : Whitland
Age : 46
Model owned : 306 Rallye,xsi-6 207 GT and a DC5
Dream Car : too many at the moment
Points : 39998
Date Joined : 2008-07-14

http://www.swfco.net

Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum