OZ WHEEL SPACERS 21MM

they are made by oz , the inner center bore where it meets the hub
is 65mm , the outer section which would be the new hub center is 68mm
which i believe is standard oz bore . they are both compatible
with 4x100 and 4x108 pcd systems .

so all you need is some spigot rings to go inside to reduce 65mm to 60mm
and they are good to bolt onto renault hubs .
there is slight damage to the edges of the outer bore but that would not affect
the operation of these .

got 2 pairs of them in similar condition , £20 a pair plus 5 postage or pick
up from penarth s.wales

hi mate wld these make renault wheels fit on citroen ? do you know/

Don't think so Dan, as Turkish® said Renault wheels have a 60mm centre bore and Citroen use 65mm.

Renault are 4x100mm Citroen 4x108mm you'd need a spacer that bolts to the hub using 4x108mm and have threads at 4x100mm for the wheel to bolt to plus have the hub diameter to mount to the Citroen hub 65.1mm and then go to 60.5mm for the Renault wheel, then the thickness of spacer would be down to the offset of the Renault wheel

I.E a Renault wheel with a ET38 offset would need a 20-23mm spacer

Can be made to fit but would be costly

rollerdan wrote:hi mate wld these make renault wheels fit on citroen ? do you know/

no but they would make oz wheels to fit on a citroen .

renault wheels are 4x100 citroen are 4x108 to start with .

I could do to buy these off you, do you still have them, or even just one?
Thanks.